So I have the gymnasticon running with ANT+ on a RPi Zero W, connecting to IC4.
IC4 has difficulty levels from 1-100. When I start pedalling at 32 difficulty, the reported power is about 140-160, which is fine. But when I start doing 3-minute intervals, where I switch the difficulty between 32 and 55, at some point gymnasticon reports pervious power as if I did not change the difficulty.
That is, if I pedal for 3 minutes at 32 the reported power is 140-160. Then I change the power to 55, but the reported power stays at 140-160 (should be 200-230). During half an hour of training, I need to restart the RPi once. Then the power is reported correctly again. This is not happening each time. On average, once every half an hour from what I have seen so far.
So I have the gymnasticon running with ANT+ on a RPi Zero W, connecting to IC4.
IC4 has difficulty levels from 1-100. When I start pedalling at 32 difficulty, the reported power is about 140-160, which is fine. But when I start doing 3-minute intervals, where I switch the difficulty between 32 and 55, at some point gymnasticon reports pervious power as if I did not change the difficulty.
That is, if I pedal for 3 minutes at 32 the reported power is 140-160. Then I change the power to 55, but the reported power stays at 140-160 (should be 200-230). During half an hour of training, I need to restart the RPi once. Then the power is reported correctly again. This is not happening each time. On average, once every half an hour from what I have seen so far.